EasyManua.ls Logo

SeQual Eclipse - 12. Eclipse beeps once every 1-3 min’s (No LEDs) when running on a 12 volt DC System (... Car, RV, Boat)

SeQual Eclipse
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11436 Sorrento Valley Road • San Diego, CA 92121 • www.sequal.com 858.202.3100
23
Troubleshooting Guide
Troubleshooting Guide
12. Eclipse beeps once every 1-3 min’s (No LED’s) when running on a
12 volt DC System (… Car, RV, Boat)
A. Does the vehicle have a 12VDC power system? (YES or NO)
i. If “NO” The Eclipse is designed to run on a 12 volts system, and cannot operate on
a 6 or 24 volt system.
ii. If “YES”, Is there adequate power available to operate the Eclipse (15 amps and
higher for a setting of 2.5 &/or 3.0 continuous, all other setting can use a minimum
of10 amp)
iii. If “NO”: The Eclipse requires a minimum of 12 volts and 10 – 15 amps to operate. If
the vehicle electrical system is inadequate, your Eclipse will switch over to the
Power Cartridge as a back up power source, if the Power Cartridge is installed and
charged up.
iv. If “YES”: The Eclipse has detected, that at some time, the voltage from the outlet
dropped below 11.5 VDC. The Eclipse will attempt to reconnect to the car’s
electrical system if the voltage rises above 11.5VDC. A qualified technician may
need to inspect the vehicle outlet insure that the proper power is available.
*Note: If Eclipse can be used in the Pulse Mode do so. This mode of operation reduces the power
requirements from the vehicle electrical system, or use the Power Cartridge to continue to run
Eclipse
.

Other manuals for SeQual Eclipse

Related product manuals