SeQual Eclipse - 11. Power Cartridge will not charge (cascade) when it is in the Eclipse, and Eclipse is running off an AC; DC Power Source.

11436 Sorrento Valley Road • San Diego, CA 92121 • www.sequal.com • 858.202.3100
22
Troubleshooting Guide
Troubleshooting Guide
11. Power Cartridge will not charge (cascade) when it is in the Eclipse,
and Eclipse is running off an AC / DC Power Source.
A. Is the Power Cartridge Full? (YES or NO)
i. If “YES” then the cartridge is completely charged. No further action required
ii. If “NO” Is the external power adapter (AC or DC Adapter) connected? (YES or NO)
iii. If “NO” then Eclipse is operating from the Power Cartridge, and not the AC or DC
adapter, “There are no charging capabilities at this time.”
iv. If “YES”
1. Ensure that all power cords are properly connected to there receptacles.
2. Ensure that the LED is illuminated “Green on the AC or DC Adapter unit
B. Has the Eclipse recently been operating from the Power Cartridge for a prolonged period
of time or on the higher continuous liter flows (2.5 or 3.0 continuous)? (YES or NO)
C. If “YES”: The Power Cartridge may have over heated. Remove the Power Cartridge from
Eclipse and allow it to cool in a well ventilated area for approximately 20 min’s, then
return the Power Cartridge to Eclipse for recharging.
D. If “NO”: There may be a problem with the Eclipses Charging System “Your (1) Eclipse,
(2) Power Cartridge or (3)External Power Charger may be faulty. “Exchange out the unit
for evaluation and possible repair”.
Reasons why a Power Cartridge will not charge
• Power Cartridge is fully charged (10 bars for Eclipse & 4 bars for Eclipse 2)
• Power Cartridge is being used (See Loss of external power,)
• Power Cartridge is too warm. (remove & allow to cool for approximately 20 min’s)