Sercomm RC8221 - Chapter 5 Web-based Management; Connecting and Accessing the Camera

28
Chapter 5
Web-based
Management
This Chapter provides Setup details of the Network Camera’s Web-
based Interface. This Chapter is for the Camera Administrator only.
Introduction
The Network Camera can be configured using your Web Browser. The Network
Camera must have an IP address which is compatible with your PC.
The recommended method to ensure this is to use the supplied Windows-based
Wizard, as described in Chapter 2 - Basic Setup.
Connecting to Network Camera
• If using only your Web Browser, use the following procedure to establish a
connection from your PC to the Network Camera:
• Once connected, you can add the Network Camera to your Browser's Favorites
or Bookmarks.
Connecting using your Web Browser
1. Use the Windows utility to get the IP address of the Network Camera.
2. Start your WEB browser.
3. In the Address box, enter "HTTP://" and the IP Address of the Network Camera.
4. You will then be prompted for a username and password.
• If using the default values, enter administrator for the name, and
leave the password blank.
• Otherwise, enter the Administrator ID and Administrator Password set on
the Maintenance screen.
5