6
pressed and held over 10 seconds, the settings of Network
Camera will be set to their default values.
Note:
After this procedure is completed, the Power LED will blink three
times to confirm that the reset was completed successfully.
Power LED
(Green)
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will take
15 to 20 seconds.
Network//WPS
LED
(Green, Amber)
On (Green) - Network (Wireless or LAN) connection is available.
Off - Wireless or LAN is not connected or camera is not
sending/receiving data.
Blinking (Green) - Data is being transmitted or received via the
LAN or Wireless connection.
On (Amber) - If the LED is on for 5 seconds, the WPS function is
failed.
Blinking (Amber) - WPS function is being processed.
Package Contents
The following items should be included: If any of these items are damaged or
missing, please contact your dealer immediately.
1. Network Camera
2. Camera Stand
3. Power adapter
4. Installation CD-ROM
5. Quick Installation Guide
To Next Page
Loading...
