Suspension Geometry Front
Downstops 0mm
Set-up ride height 6mm
Camber Left -1.5
Camber Right -1.5
Track-Width 200mm
Toe-in -1.0
Caster setting (mm in front) 3mm
Roll center (mm below below pivot point) 2mm
Upstop 2mm
Suspension Geometry Rear
Downstops 7mm
Set-up ride height 6mm
Camber Left -3.0
Camber Right -3.0
Track-Width 200mm
Toe-in +2.0
Roll center position upper Bottom inner
Roll center position lower Bottom
DRS arm position Level
Shock Absorbers Front
Springs Yellow
Oil 30W
Holes 3
Cylinder type Composite
Shock tower position 2nd
Shock Absorbers Rear
Springs Yellow
Oil 30W
Holes 3
Cylinder type Composite
Shock tower position 1st
Wishbone mounting position Outside
Anti-roll bar front
Thickness N/A
Position Flat
Anti-roll bar rear
Thickness N/A
Position of top pivot point (mm from end of bar) 0mm
Position on lower arm Outside
DEFAULT SETUP SHEET
To Next Page
Loading...
