Read Me First…
Unpacking -
Follow the steps below to unpack your Servomex analyzer.
1. Examine the condition of the packaging and its contents. If any damage is apparent,
immediately notify the carrier and Servomex. Do not proceed with the installation.
2. Check the contents against the packing slip to make sure the shipment is complete.
Unattached equipment may be shipped with the analyzer in supplemental packaging.
Shortages should be reported to Servomex immediately.
All analyzers are shipped with the following:
Item Servomex Part Number
One bottle of Hummingbird Brand E-lectrolyte Blue
Electrolyte Blue
One bottle of Hummingbird Brand
Replenishment Solution
210515
Power cord with 115 VAC connector
NOTE: No power cord is supplied with 220 VAC units.
210408
Operator Manual 211600
3. Open the analyzer door, remove any shipping materials, and verify that nothing has come
loose during transit.
4. The analyzer is set at the factory to operate on 115 VAC or 220 VAC. Locate the
voltage indicator on the rear panel beside the AC power input and verify the voltage is set
as ordered
To Next Page
Loading...
Need help?
General
