Need help?Do you have a question about the Servomex Xentra 4900 and is the answer not in the manual?
General| Technology | Paramagnetic, Infrared |
|---|---|
| Display | LCD |
| Power Supply | 100-240 VAC, 50/60 Hz or 24 VDC |
| Enclosure Rating | IP20 |
| Gas Types | Oxygen, Carbon Dioxide |
| Communication Protocols | RS232, RS485, Modbus |
| Mounting | 19" Rack |
| Gases Measured | Oxygen, Carbon Dioxide |
| Accuracy | ±0.1% O2 |
| Outputs | 4-20 mA, Alarms, Digital outputs |
| Operating Temperature | 0 to 45°C |
| Measurement Range | 0-100% (dependent on gas type) |
Covers safety, wiring, and voltage selection for connecting the analyser to mains power.
Details how to connect various signal outputs, inputs, and serial data ports.
Describes the automated calibration process, its phases, and essential setup parameters.
Provides step-by-step instructions for manual low and high calibration of specific transducers.
Configures concentration software alarm settings, levels, and hysteresis for each gas sensor.
Details the configuration, ranges, and scaling of analogue output signals.
Describes essential leak testing procedures for systems analysing toxic samples.
To Next Page
