Setra Systems Flex - Display Settings

Setra FLEX Operating Instructions
32
Phone: (800) 257-3872 | Fax: (978) 264-0292 | www.setra.com
Choose Monitor Preset A or BforthisProle.Refertothe
MonitorPresetsdenedinAlarmLimitsforeachBadgein
Room setup.
Room setup. This Monitor Preset will then apply to all the
BadgesforthatRoomwhenrunningthisProle.
Choose Control Preset A or BforthisProle.Refertothe
Control Presets dened in Control Loop Setup for each
Badge in Room setup. This Control Preset will then apply
toalltheBadgesforthatRoomwhenrunningthisProle.
3.9 Display
The Display Settings menu is where the behavior of the
Homescreenisdened.
Default to Fullscreen is a mode where all Rooms are
shown on one screen. When Default to Fullscreen is
Disabled, each Room is shown on the Home screen with
its’appropriateBadgesandProles.Fullscreenmodecan
be accessed manually using the Fullscreen icon on the
top-right part of the screen.
When Default to Fullscreen is Enabled, the Home screen
is in Fullscreen mode all the time. Each individual Room
and Badges can be viewed by touching any of the rooms.
After the Screen Timeout duration, Fullscreen mode goes
back into effect.
Screen Timeout is duration of time of screen inactivity
before the screen reverts back to the Home screen (or
Fullscreen, if so congured). This applies to inactivity
on Setup screens, accessing Fullscreen mode manually,
accessing badges, and other transient features.
Room Carousel is a feature that causes multi-room
displays to transition from one room to another, in
sequence, based on timing dened by Room Carousel
Interval. If Disabled, the room selected will continue to
be displayed on the Home screen until a touch change is
made.
Back Light is the lumens intensity of the Home screen
display and all other screens. Changing the Back Light
slider bar to more or less bright is a way of managing
the light intensity of FLEX displays in customer nighttime
and daytime applications. Move the slider to the optimum
setting for 24-hour conditions, or change the lumens
intensity via BMS control over BACnet on a schedule.