Sevcon MillipaK 4QPM - Page 35

Features Performance/Accelerator Characteristics
______________________________________________________________________________
MillipaK 4QPM Controller Manual Page 35 13/08/03
Examples:
1. The Accelerator Characteristic is set to Dual Slope, the Creep Speed personality is set to 0%
and the Maximum Speed personality is set to 100%. If the accelerator push was at 70%, then
the accelerator demand and the vehicle speed demand would be 35%.
2. Same conditions as (1) but the Creep Speed personality is set to 10% and the Maximum Speed
is set to 75%. The accelerator push is still 70% and the accelerator demand is still 35%, but
now the vehicle speed demand is 32.75%. i.e.:
()
()
%75.32
100
35
107510
100
Demandr Accelerato
Speed CreepSpeed MaximumSpeed Creep Demand Speed
=






×−+=






×−+=