Sevcon MillipaK 4QPM - Cutback speeds

Features Standard Features/Cutback Speeds
______________________________________________________________________________
MillipaK 4QPM Controller Manual Page 43 13/08/03
Cutback speeds
There are 2 cutback switch inputs as standard. Each one has an associated personality to adjust the
maximum % on when the switch is active. When both switches are active together, the lower
speed is selected. The cutback speed inputs are usually normally closed so that a wire off type
fault or bad connection initiates a lower speed.
Immediate Cutback Speed 1
Calibrator Menu Reference:
6.01
Minimum Maximum Step Size Typical Value
0% 100% 1% 100%
Immediate Cutback Speed 2
Calibrator Menu Reference:
7.01
Minimum Maximum Step Size Typical Value
0% 100% 1% 100%