Page 10 of 27
MFC could begin operating after it was well connected with professional cable and corresponding Flow Readout
Box. 7K-MFC connection is showing in the following figure 7.
Attention :
D07-7K is upgrade of D07-7A; D07-7K applied affixed components and international standard D
connector. Compared with 7A, they have the same position of connector lead but opposition of serial
numbers. 7K could possible substitute for 7A, cables of 7A could directly connect to 7K but only different
of its lock device, normally, it should change its connectors or cables while substitution.
7KM-MFM connector (figure11) is as same as connector of 7K-MFC, only compared with MFC accessories that
lacks of “ Valve drive” and “Set” two wires.
Figure 8. D07-7KM Electrical Connector
6
5
4
3
2
1
15
14
13
12
11
10
9
8
7
-15VDC
-15VDC
+15VDC
Zero adjustment
Signal common
GND
Common
Power common
Output(0~5VDC)
+15V
-15V
To Next Page
Loading...