SHAREBOT Q Dual - Working with Sharebot Q Dual; Preliminary Actions; First Print

To Next Page

To Previous Page

Working with Sharebot Q Dual

Set basic features and advanced parameters

Create Gcode files for Sharebot Q Dual

Preliminary actions

Before making the first work it is necessary to:

● Place the machine in a large and adequate area;

● Connect the C13 - IEC 60320 power cable to the socket on the side of the machine;

● Start the machine using the ON / OFF switch;

● Check that the display lights up;

● Apply a thin layer of Magigoo on on the printing surface;

● Load the desired filament in the selected extruder (see “filament management”)

The tools supplied must be kept near the machine.

FIRST PRINT

A *.gcode file is pre-loaded in the machine's internal memory to carry out the first printing

process;

To print the first model follow this procedure:

At the end of printing, wait for the plate to cool down:

the object will begin to detach itself from the print bed, without that

it is necessary to mechanically remove it from it with spatulas or cutters!

Once removed the object, apply a new layer of "Magigoo" in the area occupied by

previous print.

The machine leaves the factory calibrated and ready to use (Plug and Play).

SELECT:

File from memory

select the *.GCODE file