Package Contents
Fist of all, check that there are no damages to the machine and that all items listed below
are included in the package or in the Sharebot toolbox.
Your package should contain:
● A box with the Welcome Kit;
● 3D printer Sharebot Q Dual with the 0.4 and 0.8 mm nozzles.
Welcome Kit
The Welcome Kit contains:
● a Sharebot toolbox;
● PLA filament spool;
● magnetic support for the spool 750 gr;
● magnetic support for the spool 2,2/4 Kg;
● power and Rj45 cable;
Sharebot toolbox
The Sharebot toolbox contains:
● Nippers
● Cutter
● Allen screwdriver size 1.5 / 2 / 2.5
● "Unlocks nozzle" tools
● USB stick with manual and printing profiles
● Metric feeler gauge
Test materials
A sample spool (PLA) is provided for free for initial testing,
The material is guaranteed by Sharebot Srl.
Spool from other suppliers can be used under fully responsibility of the end user.
Unpacking the printer
Before powering up the Sharebot Q Dual 3D printer it is necessary to unlock the extruders
and Z carriages following this procedure (see instructions inside the printer):
1) Cut the clamp that blocks the extruder carriage on the X and Y axis;
2) Remove the 4 plastic blocks of the Z plane by pulling the wire that joins them together;
3) Place the printing surface on the printing bed and lock it using the clips in the designed
position
The original packaging must be kept for the duration of the warranty. Machines without
original packaging may not be accepted by technical assistance.
7
To Next Page
Loading...