Printing plate & dimensions
● The printing plate is a galvanized steel surface on which is placed a borosilicate
glass. The object is constructed in additive mode on glass. The printing plate leaves
the factory ready to use, calibrated on the specific glass (Magigoo on one side of it).
● Sharebot Q Dual's print volume during dual printing process is:
X = 250 mm Y = 700 mm Z = 300 mm
● Sharebot Q Dual's print volume during mono printing process is:
X = 270 mm Y = 700 mm Z = 300 mm
Filament management
To load a new filament spool follow the guided procedure:
● Place the spool in the compartment, paying attention to its orientation, it must take
place in a clockwise direction;
● Cut the filament at the end of the spool;
● Launch the filament change option (1st or 2nd) from the printer menu (gear →
prepare → Filament management)
● Wait for the previous filament to be retracted (with a new printer not present),
remove the guide from its quick coupling and remove the filament by unlocking the
dragger gear using the specific lever;
● Insert the new filament till the hot-end, lock the dragger gear using the specific lever
and then click OK on the screen button for confirmation;
● Wait the nozzle to extrude a few millimeters of the inserted material and click the
on-screen confirmation button to end the operation
Extrusion stopped
This is a safety procedure to stop the over-extrusion of the new filament: if you
forget to end the “change filament” procedure the extrusion will stop itself after five
minutes of extrusion and the printer will display “Extrusion stopped”.
11
To Next Page
Loading...