Sharp AR-235

LIST OF KEY OPERATOR PROGRAMS
122
KEY OPERATOR’S GUIDE
Category Program Name Function Page
No.
Timer setting Auto Power Off Sets a time interval after which the copier enters
the auto power shut-off mode.
131
Auto Clear Sets a time interval after which the copier returns
to the initial settings.
131
Preheat Mode Sets the time that elapses before the copier
enters the preheat mode after copying is
completed.
132
Message Time Sets the length of time that messages are
displayed.
132
Time Out Setting Sets the time after which a print or fax job
resumes. (This program can be used only if an
optional printer expansion kit or an optional
facsimile expansion kit is installed.)
133
Enable/disable Disable Auto Paper
Selection
Prevents automatic paper selection. 134
Disable Auto Tray
Switching
Prevents automatic switching between the paper
trays.
134
Disable Job Program
Changing
Prevents stored programs from being replaced
or deleted.
134
Disable SPF/RSPF Prevents the use of an SPF or RSPF when it
malfunctions. (This program can be used only if
an optional SPF or RSPF is installed.)
135
Disable 2-Sided Copy Temporarily prevents the duplex system from
operating when it malfunctions. Allows the use of
the copier but not the duplex system.
135
Disable Stapler Prevents damage to the stapler while awaiting
repair service. (The stapler is included in an
optional finisher and this program can be used
only if the finisher is installed.)
135
Disable Centre Tray
Counting
Disables count of paper output into the copier
centre tray.
135
Disable Auto Power
Shut-off
Disables the auto power shut-off mode. 136
Disable Beep at Key
Touch
Enables or disables sounding of beep when keys
are touched.
136
Disable Backlight
Change
Disables change of the display colour. 136
00EX.book122ページ２００１年５月２５日 金曜日 午前１０時４９分