126
KEY OPERATOR’S GUIDE
KEY OPERATOR PROGRAMS
FUNCTION SETTING
The programs of this category are used to adjust various settings of copier functions. These programs
can be selected by using the and keys to highlight "FUNCTION SETTING", pressing the OK key,
highlighting the desired program, and then pressing the OK key.
Key Operator Number Change
See page 118, REGISTERING THE KEY OPERATOR CODE NUMBER.
Exposure Adjust
Use this program to lighten or darken copies in the automatic exposure mode. The exposure level can
be set for copying from the platen glass or copying from either an optional SPF or RSPF. The factory
setting is level 3.
When "EXPOSURE ADJUST" is selected and the OK key is pressed, the following display will appear.
1. Use the and keys to select the "PLATEN" (platen glass) or "SPF/
RSPF".
2. Adjust the exposure using the and keys.
3. Repeat steps 1 and 2 to adjust the other exposure level.
4. Press the OK key.
Limit of Copies
Use this program to limit the maximum number of copies per copy run which can be input in the copy
quantity display. If a number exceeding the maximum number is set in the COPY mode, the number of
copies will be changed to the maximum number when the START ( ) key is pressed. The factory
setting is 999.
When "LIMIT OF COPIES" is selected and the OK key is pressed, the following display will appear.
1. Use the numeric keys to input the desired limit.
●
A number from 1 to 999 can be set.
2. Press the OK key.
EXPOSURE ADJUST
PLATEN
SPF/RSPF
LIMIT OF COPIES
-----
[10-key]:ENTER
999
(1~999)
00EX.book126ページ２００１年５月２５日 金曜日 午前１０時４９分
To Next Page
Loading...
