Sharp AR-235

KEY OPERATOR PROGRAMS
127
7
KEY OPERATOR’S GUIDE
Margin Default
Set the initial margin shift value with this program.
When "MARGIN DEFAULT" is selected and the OK key is pressed, the following display will appear.
1. Adjust the initial margin shift value using the and keys.
●
The value can be set from 5 mm to 20 mm in 5 mm increments (from 1/4" to 1" in 1/4"
increments).
2. Press the OK key.
Erase Adjust
Set the initial setting of the amount of the erase area with this program.
When "ERASE ADJUST" is selected and the OK key is pressed, the following display will appear.
1. Adjust the value for the edge erase mode and centre erase mode
using the and keys.
●
The value can be set from 5 mm to 20 mm in 5 mm increments (from 1/4" to 1" in 1/4"
increments).
2. Press the OK key.
Initial Conditions
The copier will assume the initial settings when it is turned on, when the CLEAR ALL (CA) key is
pressed, or when the auto clear interval has elapsed after a copy run. Use this program to establish the
initial settings.
When "INITIAL COND." is selected and the OK key is pressed, the following display will appear.
MARGIN DEFAULT
1
/ 4 mm
(5~20)
MARGIN DEFAULT
1
/ 4 inch
(1/4~1)
ERASE ADJUST
1
/ 4 mm
(5~20)
ERASE ADJUST
1
/ 4 inch
(1/4~1)
INITIAL COND.
-----
NEW DEFAULT
FACTORY DEFAULT
00EX.book127ページ２００１年５月２５日 金曜日 午前１０時４９分