Required in Appendix ZB of BS EN 60950 - United Kingdom
MAINS PLUG WIRING INSTRUCTIONS
The mains lead of this equipment is already fitted with a mains plug which is either a
non-rewireable (moulded) or a rewireable type. Should the fuse need to be replaced,
a BSI or ASTA approved fuse to BS1362 marked or and of the same rating as
the one removed from the plug must be used.
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use
the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the
plug supplied either cut-off the moulded plug (if this type is fitted) or remove by
undoing the screws if a rewireable plug is fitted and fit an appropriate type observing
the wiring code below.
DANGER: The fuse should be removed from the cut-off plug and the plug destroyed
immediately and disposed of in a safe manner. Under no circumstances should the
cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock
may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT:The wires in this mains lead are coloured in accordance with the
following code:
GREEN-AND-YELLOW:Earth
BLUE: Neutral
BROWN: Live
As the colours of the wires in this mains lead may not correspond with coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the
terminal in the plug which is marked with the letter E, or by the safety earth symbol
, or coloured green or green-and-yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is
marked with the letter L or coloured red.
If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.
00EX.book3ページ２００１年５月２５日 金曜日 午前１０時４９分
To Next Page
Loading...
