30
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
RDS Radio
■
To recall stations in memory
To specify programmed types and select stations (PTY search):
You can search a station by specifying the programme type (news, sports, traffic
programme, etc. ... see page 28) from the stations in memory.
1 Press the TUNER (BAND) button to select the FM.
2 Press the PTY.TI button.
● “PTY TI” and “SELECT” will appear alternately for about 6 seconds.
3 Within 6 seconds, press the PRESET (
XX
XX
X or
WW
WW
W) button to select
the programme type.
● Each time the button is pressed, the programme type will appear. If the but-
ton is held down for more than 0.5 seconds, the programme type will appear
continuously.
4 Whilst the selected programme type is flashing (within 4 sec-
onds), press the PTY.TI button again.
● After the selected programme type has been lit for 2 seconds, “SEARCH”
will appear, and the search operation will start.
Notes:
● If the display has stopped flashing, start again from step 2.
If the unit finds out a desired programme type, corresponding channel number will
flash for about 3 seconds, and then the station name will flash for 7 seconds, and
then will remain lit.
● If you want to listen to the same programmed type of another station, press the
PTY.TI button whilst the channel number or station name is flashing. The unit will
look for the next station.
● If no station can be found, “NOT FOUND” will appear for 4 seconds.
If you select the traffic programme:
If you select the traffic programme (TP) in step 4, “TP” will appear. (This does not mean
that you can listen to the traffic information at that time.)
When a traffic information is broadcast, “TA” will appear.
To specify station names and select stations manually:
You can select a station by specifying the name (BBC R1, BBC R2, etc.) from the
stations stored in memory.
Before starting this operation, you must store one or more station names in memory.
1. Press the TUNER (BAND) button to select the FM band.
2. Press the PRESET (X or W) button to select a desired station.
3. The station name will be displayed for 3 seconds. Then the display will change as
follows.
Using the Radio Data System (RDS) (continued)
To Next Page
Loading...
Need help?
General
