31
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
RDS Radio
■
To automatically play the desired programme
(EON-PTY)
When the desired type of programme is broadcast, the radio switches to it automatically.
1 Tune in to an RDS station (when a station name is displayed).
2 Press the EON button when “EON” appears.
● “PTY TI” and “SELECT” will appear alternately for about 6 seconds.
●
If the EON button is pressed when “EON” is not displayed, “NO EON” will appear
for 5 seconds to indicate that the unit cannot enter the EON stand-by mode.
3 Whilst they are displayed, select the desired programme type by
pressing the PRESET (
XX
XX
X or
WW
WW
W) button.
● The selected programme type will flash.
4 Within 4 seconds, press the PTY.TI button.
● The selected programme type and “WAITING” will be displayed for 2 sec-
onds each.
● “PTY” will appear, and the unit will enter the EON-PTY stand-by mode.
5 When the specified programme starts on an ON (other network)
station, the unit will automatically switch to the station and “PTY”
will flash.
6 When the programme is over, the unit will automatically return
to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
(“Programme type” →“WAITING”)
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again.
(“PTY” will go out.)
About the PTYI (Dynamic PTY Indicator):
“PTYI” (Dynamic PTY Indicator) will appear whilst the Dynamic PTY station is received.
Dynamic PTY indicates that the PTY for the station tuned in, or the PTY referenced in
the EON data, is assessed whenever the programme changes and may be changed.
PTYI
Lights up
Goes out
Meaning
Tuned into a dynamic PTY station.
Tuned into a static PTY.
● When “PTYI” appears, press the DISP MODE button to check the type of the
current programme.
To Next Page
Loading...
Need help?
General
