22
INITIAL SETTINGS
8
Press the [ENTER] key.
9
Press the [MENU] key.
Press the [MENU] key to
exit.
SETTING THE DATE AND TIME
The date and time that appear in the display are printed at the top of each page you transmit. Set the date and time
by pressing the keys on the operation panel as shown below.
If you enter an incorrect number, press the [CLEAR] key ( ) and re-enter the number.
The time can be displayed in 12-hour or 24-hour format. "Month/Day/Year", "Day/Month/Year" or "Year/Month/Day"
can be selected for the order of display of the date.
Use the following procedure to set the date and time:
1
Press the [MENU] key.
2
Press the [ ] key ( ) or [ ] key ( )
until "2:ENTRY MODE" appears, and
then press the [ENTER] key.
3
Press the [ ] key ( ) or [ ] key ( )
until "2:DATE&TIME SET" appears,
and then press the [ENTER] key.
4
Enter the year (four digits), month (two
digits), and day (two digits) with the numeric
keys and then press the [ENTER] key.
The year can be entered from 2008.
5
Enter the time (hour (two digits) and
minute (two digits)) with the numeric
keys.
Enter the hour in the following range:
When 12-hour format is selected: 01 to 12
When 24-hour format is selected: 00 to 23
6
Press the [ ] key ( ) or [ ] key ( )
to select "AM" or "PM".
When 24-hour format is
selected, do not perform
this step.
7
Press the [ENTER] key.
8
Press the [MENU] key.
Press the [MENU] key to
exit.
"2:ENTRY MODE"
Selection
"2:DATE&TIME SET"
Selection
ENTER DATE (2008-)
2008/01/02
Year Month Day
!AR-FX13_sec.book 22 ページ ２００９年５月１１日 月曜日 午後２時２４分
To Next Page
Loading...
Need help?
General
