82
TD (TONER/DEVELOPER) CARTRIDGE REPLACEMENT
When toner is low, the error indicator will light up and "TD CARTRIDGE IS NEAR
EMPTY." will appear in the display. For information on purchasing a new TD (Toner/
Developer) cartridge, see "ABOUT SUPPLIES AND OPTIONS" (p.90). If copying is
continued while the indicator is lit, copies will gradually become lighter until the toner
runs out. When the toner runs out, the machine will stop operating, the error indicator
will blink, and "REPLACE THE TD CARTRIDGE" will appear in the display. Follow
the procedure below to replace the TD (Toner/Developer) cartridge.
1
Open the bypass tray, and
then open the side cover
while pressing the side
cover open button.
2
Push gently on both sides of
the front cover to open the
cover.
• After the machine stops, it may be possible to make a few more
copies by taking the
TD cartridge out of the machine, shaking it
horizontally, then reinstalling it. If copying is not possible after this
operation, replace the
TD cartridge.
• During a long copy run of a dark original, "TONER
REPLENISHMENT IN PROGRESS" appears in the display, and the
machine may stop even though toner is left. The machine will feed
toner up to 2 minutes and then the ready indicator will light up. Press
the [START] key ( ) to resume copying.
Note
!FO-2080.book 82 ページ ２００９年５月１５日 金曜日 午前１０時４２分
To Next Page
Loading...
Need help?
General
