Sharp FO-2080 - Page 28

24
INITIAL SETTINGS
To change the order of display of the date, follow the steps below:
1
Press the [MENU] key.
2
Press the [ ] key ( ) or [ ] key ( )
until "4:USER PROGRAM" appears,
and then press the [ENTER] key.
3
Press the [ ] key ( ) or [ ] key ( )
until "23:DATE&TIME FORMAT"
appears, and then press the [ENTER]
key.
4
Press the [ ] key ( ) or [ ] key ( )
until "2:DATE FORMAT" appears, and
then press the [ENTER] key.
5
Press the [ ] key ( ) or [ ] key ( )
to select the display order.
The selections are as
follows:
1:MMDDYYYY
2:DDMMYYYY
3:YYYYMMDD
6
Press the [ENTER] key.
7
Press the [MENU] key.
Press the [MENU] key to
exit.
This selection does not affect the order of
the date that appears in "2: DATE & TIME
SET" in step 4 on page 22.
The date in this step always appears in the
format "YYYYMMDD".
"4:USER PROGRAM"
Selection
"23:DATE&TIME FORMAT"
Selection
"2:DATE FORMAT"
Selection
Note
!AR-FX13_sec.book 24 ページ ２００９年５月１１日 月曜日 午後２時２４分