Watching TV
Simple operations for watching a TV program
POWER indicator
\
00000
.............o
! l
CH v / ^ POWER
K3 CD CD
@@@8
®®®
®N®
U<zY
Turning off the power ....
Press POWER on the TV!DVD, or POWER on the
remote controt
* The TV enters standby mode and the image on the screen
disappears
* The POWER indicator on the TViDVD changes to Red
• If you ere not going to use this TViDVD for a long period of
time, be sure to remove the AC cord from the power oulIet.
• Weak electric power is stiII consumed even when POWER
is turned off
Changing channels i
You can change channels in several ways
Method 1
Using CH ^/v on the remote control unit or on the
TV/DVD
• Ifyour cable-TV system inciudes analog and digital
channels using the same channel number, your channel
up function will scroll through the analog channel first,
then the digita! channel Although it may appear as though
the channel does not change, it actually moves from the
analog to the digital channel in sequence
if you use channel-down, it will move in reverse, from the
digital channel to the analog channel
TV status indicator (POWER)
ON Lighting (Green)
OFF/Standby Lighting (Red)
Method 2
Using remote control buttons 0-9, o (DOT) to select
channels for VHF/UHF/CATV/DIGtTAL
To select a 1or 2-digit channel number (e. g, Channel 5):
Press 5
Preparation
Perform the following steps before you press POWER
on the remote control unit
1o Insert the batteries into the remote control unit
(See page 9 )
2. Connect the antenna cable to the TV/DVD (See
page 13.)
3o Plug in the AC cord to the AC outlet. (See page 8 )
Turning on the power
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number
,' When you enter 0-9 only, channel selection will be made
if there is no operation within a few seconds
To select a 3-digitchannel number(e g,, Channel 115):
Press 1-.1-_5
To select a 4*digit channel number (e g.,, Channel 22_1):
Press 2._-2-e - (DOT) -el
Press POWER on the TV/DVD, or POWER on the
remote control
• POWER indicator (Green): The TV/DVDS is on ("PLEASE
WAIT" will appear for a few seconds on the screen )
Select the TV mode
Press TVIDVD to select the TV mode
• When you enter 0-9 only, channel selection witl be made
if there is no operalion within a few seconds
• If you press 0 by itself in "AIR" reception, nothing wilt
happen
° Complete the above steps within a few seconds
. When you enter 0-9 and * (DOT), channel selection will
be made if there is no operation within a few seconds
• The LANGUAGE setup menu wil! appear automatically
when TV MENU is pressed on for the first time
To Next Page
Loading...
