Connecting a PC (Personae computer)
Viewing an image from a PC
Use the INPUT5 (PC) terminals to connect a PC
• The PC input terminals are DDC1i2B-compatib]e.
• Refer to page 35 for a list of PC signals compatible with the System
• Make sure to select the same signal vatues for the output signal of a PC and the input signal of the TV/DVD set before
connecting with the PC (See page 35)
• Depending on the PC being used, images may not be shown without converting the output signals intoexternal output
Please refer to your PC's manuals regarding converting to external output
• Connect the RGB cable making sure
that it tits correctly into the terminal
Then f#mly secure the connectors by
tightening the screws on both sides
of the plug
PC
Signal names for 15-pin mini D-sub connecter
_.( @® @@¢ "L-_ P!n_' s!gnalname
U\ @@@(b<elt) Q
_[_@ @ @ @ ]-- @
. ®
®
®
PinNo.
n ®
G 0
B ®
Notconnecled {_
CSYNC
_._ Pin No, Signal name
@" - Not connec{ed
GND (Ground) @ SDA
GND (Ground) @ HD
+5v @ VD
GN# (Gr#und) (_ SCL
• Pin No 5 is not used for inputting the signal.
• Pin No 9 is not connected with the supplied RGB cabte
Displaying an image from a PC
[_15PLAY TVJOVO EJECt i
CDCD_
@@@
To view an image from a PC, perform the following
procedure
(_ Select the INPUT5 (PC) mode using INPUT on the
remote control or the TV/DVD set {See page 14 )
Q Select the PC input signal (See page 35 )
0 Adjust the "PICTURE." items if the PC image does
not come in clearly (See page 35)
z: _IPUTZ
_- 34
To Next Page
Loading...
