QUICK REFERENCE
If the remote control fails to operate TV/DVD functions, replace the batteries in the remote control unit
t Open the battery cover
.....
2 Insert two "AA" size batteries
(supplied with the product)
3 Close the battery cover
/
• Place the batteries with their terminals
corresponding to the (+) and (-)
indications in the battery compartment
Improper use of batteries can result in chemical leakage or explosion Be sure to follow the instructions below
• De not mlx batteries of different types. Different types of batteries have different characteristics
• Do not mix old and new batteries Mixing old and new batteries can shorten the life of new batteries or cause chemical
leakage in old batteries
• Remove batteries as soon as they are worn out Chemicals that leak from batteries that come in contact with skin can
cause a rash If you find any chemical leakage, wipe thoroughly with a cloth
• The balteries supplied with this produc! may have a shorter }ire expectancy due to storage conditions.
• Ifyou will not be using the remote control unit for an extended period of time, remove batteries from it
Remote control 30°
sensor
IMPORTANT:
The POWER indicator on the television should light GREEN indicating you have power to the TV/DVD
If the POWER indicator on the television still does not light up, press POWER on the remote control to turn the
power on
IMPORTANT:
IF THE UNIT DOES NOT POWER ON - UNPLUG THE TELEVISION FROM THE OUTLET AND REPEAT THE
INSTALLATION STEPS.
IF YOU STILL ENCOUNTER NO POWER, PLEASE CONTACT US AT !-800-BE-SHARP.
Please refer to the BASIC ADJUSTMENT SETTINGS SECTION and basic Initial setup functions and USING
EXTERNAL EQUfPMENT SECTION for other device connections (DVD, VCR, AUDIO, etc) in your operation
manual
To Next Page
Loading...
Need help?
General
