7-67
SYSTEM SETTINGS
Contents
Network Settings
● Add or Change Extra Preset Ratios
7-98X Reduction –
X Enlargement –
● Setting a Maximum Number of Copies 999 7-98
● Initial Margin Shift Setting
7-99X Side 1
10 mm (1/2")
X Side 2
● Erase Width Adjustment
7-99X Edge
10 mm (1/2")
X Centre
● Card Shot Settings
7-99X Original Size X: 86 mm (3-3/8") Y: 54 mm (2-1/8")
X Fit to Page Disable
● Initial Tab Copy Setting 10 mm (1/2") 7-99
● Disabling Deletion of Job Programs Disable 7-99
● Disabling of Bypass-Tray in Duplex Copy Disable 7-99
● Disabling of Auto Paper Selection Disable 7-99
● Auto Selection Setting of Tray that is Supplied the Paper Disable 7-100
● Initial Colour Balance Setting Factory Default State 7-100
● Auto Colour Calibration – 7-100
●
B/W 600dpi x 600dpi Scanning Mode for Document Feeder
Disable 7-101
● B/W Quick Scan from Document Glass Enable 7-101
Item Factory default setting Page
■ Network Settings
7-102
● IPv4 Settings DHCP 7-102
● IPv6 Settings Disable 7-102
● Enable TCP/IP Enable 7-103
● Enable NetWare Enable 7-103
● Enable EtherTalk Enable 7-103
● Enable NetBEUI Enable 7-103
● Reset the NIC – 7-103
● Ping Command – 7-103
Item Factory default setting Page
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
