MX-5111N MX-LC11 (LARGE CAPACITY TRAY) 6 – 4
6) In the case of a shift to the left, lift the grip so that the height
adjustment check rib is in the same line with the axis line of the
mounting plate upper, and insert the large capacity tray unit.
7) Tighten the loosened screw.
D. Connector connection
1) Remove the screw, and remove the connector cover.
2) Connect the connector, and tighten the screw.
E. Paper size switch
(1) Paper size switch from A4 to LT
Since the factory setting of the paper size is A4, if paper size switch
is required, perform the following procedures.
1) Slowly pull out the tray until it stops.
2) Loosen the stopper fixing screw (1 pc) on the right lower side
of the tray so that the stopper does not function.
3) Pull out the tray again until it stops.
To Next Page
Loading...
