MX-5111N MX-PNX6A/B/C/D (PUNCH MODULE) 16 – 5
* When not the range of specification, progress to the proce-
dure of "F. Adjustment".
If the adjustment is not required, remove the screw from the
screw hole directly and push the caster into it until the instal-
lation fixing. (MX-FN11 only)
F. Ad j u s t m e nt
* Refer to the adjustment procedure of each finisher.
G. Install to main unit
1) Engage the finisher that has installed punch unit to the main
unit.
2) Open the front door of punch unit.
3) Secure the main unit and the punch unit with the fixing screw
(Packed items of the MX-FN11).
4) Close the front door of punch unit.
5) Install the fixing screw (Packed items of MX-FN11) on rear
side.
6) Install the rear cover of punch unit with the fixing screws.
1
: '11/Jul/25
To Next Page
Loading...
