4-14
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
FAXING A TWO-SIDED ORIGINAL
Follow the steps below to automatically transmit both sides of a two-sided original.
1
Press the [DUPLEX] key on the operation panel and select "2-Sided".
2
Select "Portrait-Booklet", "Portrait-Tablet",
"Landscape-Booklet", and "Landscape-Tablet" with the
[] or [] key.
• Booklets and tablets Two-sided originals that are bound at the side are booklets, and
two-sided originals that are bound at the top are tablets.
• Duplex scanning is canceled when the transmission is completed, or when the [CA]
key is pressed.
• Duplex scanning of two-sided originals is only possible when a Document feeder is
used. Automatic scanning of both sides of an original is not possible when the
document glass is used.
• The image of the back side of the original is rotated 180 degrees if needed at the time
of transmission, and thus there is no need to change the orientation at the receiving machine.
• To cancel duplex scanning, select "1-Sided" in step 1 and then press the [OK] key.
• Only the following two-sided document sizes can be used:
8-1/2
"x 14", 8-1/2 "x 13-1/2", 8-1/2 "x 13-2/5", 8-1/2 "x 13", 8-1/2" x 11",A4
3
Press [OK] key.
To Next Page
Loading...
Need help?
General
