4-18
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
If the receiving party is busy
If the receiving party is busy, the transmission is temporarily canceled and then automatically re-attempted after a brief
interval. (Two attempts are made at an interval of 3 minutes.*
1
)
If you do not want the machine to re-attempt the transmission, press the [FAX STATUS] key and cancel the job. (â–ºpage
4-21)
*1 The settings can be changed in the system settings. (See Recall Setting (Busy) (page 7-20))
If an error occurs that prevents transmission
If an error occurs that prevents transmission or the receiving machine does not answer the call within 45 seconds*
2
, the
transmission is stopped and then automatically re-attempted later. One attempt is made at an interval of
1 minute.*
2
) If you do not want the machine to re-attempt the transmission, press the [FAX STATUS] key and cancel the
job. (â–ºpage 4-21)
This machine also supports error correction mode (ECM) and is set to automatically resend any part
of a fax that is distorted due to noise on the line.*
3
*2 The settings can be changed in the system settings. (See Ring Timeout In Auto TX (page 7-20) and Recall Set (Err)
(page 7-20).)
*3 If the other fax machine does not support ECM or ECM is not operating, error correction will not take place.
To Next Page
Loading...
Need help?
General
