4-59
FACSIMILEâ–ºOTHER FUNCTIONS
ERRORXXXXXX Line conditions prevented the transmission from taking place normally.
A code used by service technicians appears.
XX-XX OK When group dialing or broadcast transmission was performed,
xxx- : Indicates total number of transmissions.
xxx OK: Indicates completed transmissions.
Reception result Explanation
OK Reception was completed successfully
P. FAIL The power was turned off or a power failure occurred.
MEMORY FULL The image memory became full during substitute reception to memory.
LENGTH OVER The transmitted document was over 800 mm long and therefore could not be received.
NO RX ROLL When polling was attempted,
Your fax number (sender's number) was not programmed in your machine.
Your fax number was not programmed as a polling passcode number in the other machine.
RX NO POLL When polling was attempted,
The other machine did not have a polling function.
The other machine did not have a document stored in polling memory.
ERRORXXXXXX Line conditions prevented the reception from taking place normally.
A code used by service technicians appears.
XX-XX OK When serial polling ended normally,
xxx- : Indicates total number of transmissions.
xxx OK: Indicates completed transmissions.
JUNK FAX ERR Fax reception was denied by the reception denial function.
Sending result Explanation
First two digits
Last four digits
First two digits
Last four digits
To Next Page
Loading...
Need help?
General
