1-20
BEFORE USING THE MACHINEâ–ºLOADING PAPER
Setting orientation of the print side
The setting orientation varies for the print side of paper, depending on the tray used. For "Letter Head" and
"Pre-Printed", set the paper in the reverse orientation.
Place with the print side facing the direction indicated below.
Paper that cannot be used
• Embossed paper
• Tab paper
• Special media for an ink jet printer
(fine paper, glossy paper, glossy film, etc.)
• Carbon paper or thermal paper
• Pasted paper
• Paper with clips
• Paper with fold marks
• Torn paper
• Oil-feed transparency film
• Thin paper less than 15 lbs (55 g/m
2
)
• Heavy paper as thick as 80lbs. cover (220 g/m
2
) over
• Irregularly shaped paper
• Stapled paper
• Damp paper
• Curled paper
• Paper whose print side or reverse side has been already printed on by another printer or multifunction device.
• Paper with a wave-like pattern due to moisture absorption
• Paper with creases
• Paper with dust
Non-recommended paper
• Iron-on transfer paper
• Perforated paper
Tray In normal status With letter head or pre-printed paper set
Trays 1 - 2 Facing up Facing down
Bypass Facing down Facing up
To Next Page
Loading...
Need help?
General
