MX-M753N AR-PN4 6 – 1
MX-M753N
Service Manual
[6] AR-PN4
1. Unpacking
A. Removal of the interface punch unit
B. Removal of the fixing member
1) Remove the fixing member
C. Check the packed items
1) Check that all the items are included in the package.
NOTE: Be sure to use the punch label bundled with the finisher.,
and never use the punch label bundled with the punch unit.
2. Installation
<Note before installation>
* Before starting installation, check to insure that the data lamp on
the operation panel is not on or blinking.
A. Turn off the power of the main unit
1) Turn OFF the power switch on the operation panel.
2) Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
Punch position label 2 pcs.
To Next Page
Loading...
Need help?
General
