MX-M753N MX-PKX1 16 – 1
MX-M753N
Service Manual
[16] MX-PKX1
1. Unpacking
A. Parts included
NOTE:
• N model
To set up the PS driver, do not use the CD-ROM which is
included in the MX-PKX1 but use the PCL CD-ROM which is
included in the main unit.
• U model
In the case of the U model, the PCL CD ROM is not packed with
the main unit. It is packed with the optional printer expansion kit
MX-PB13.
2. Installation
<Note before installation>
NOTE: To enable PS3, the product key must be acquired. (For
details of the acquiring method of the product key, refer to
the distributor.)
Write down the acquired product key on the product key
sheet and pass it to the user.
A. Preparation for enabling PS3
1) To enable PS3, enter the product key by the key operation of
the copier machine.
a) Touch [PRODUCT KEY INPUT].
b) Touch the input column.
c) Enter the product key with the 10-key, and touch [OK] key.
2) After completion of the product key entry, turn OFF the power
switch and the main power switch and turn them ON.
B. PS3 check
1) Print the test page in PS3 fonts by the key operation of the
operation panel. (Select the PS font list by the procedures
described in the data list print printer test page of the system
setup guide.)
Check to confirm that printing is made normally.
No. Packed part names Quantity
1 CD-ROM (For Screen Font) 1
2 Product key sheet 1
1 2
To Next Page
Loading...
Need help?
General
