Sharp UX-1300 - Page 63

REMOTE OPERATIONS
5
When
you
have
finished
listening
to
your
messages, you can do any of the follow-
ing:
e Erase all messages: To erase all of
the messages in the box, press "3",
"3, and ar: a
e Repeat playback: To listen to your
messages again, press "7" and "#".
e Perform other operations: You can
enter any of the commands described
in the following section, "Other remote
operations".
e Hang up: If you do not erase your
messages first, they will be saved and
any new messages will be recorded
after them. If you want the
UX-1300/1400 to resume normal
operation immediately, press "3¢"
twice before hanging up (in some
cases, particularly when the Transfer
function is used, the UX-1300/1 400
may not accept new calls for one or
two minutes after you hang up unless
you first press "%" twice).
Comments:
@
When
a
remote
command
is
accepted
by
the
machine,
you
will
hear
one
beep.
If
an
incorrect
command
is
entered,
you
will
hear
four
beeps.
In
the
latter
case,
re-enter
the
correct
command.
®@ When entering a command, do not pause longer than 10 seconds between each
digit.
If
you
do,
a
4-beep
error
signal
will
be
issued
and
the
digits
entered
up
to
that point will be disregarded. In this case, re-enter the command from the
beginning.
@
/fyou
make
two
errors
(causing
two
4-beep
signals
to
be
issued)
while
entering
your
remote
code
number,
the
line
will
be
disconnected.
This prevents
unauthorized
people
from
attempting
to
guess
your remote
code
number.
e
/fyou
pause
for
longer
than
60
seconds
before
entering
a
command,
you
will
be
disconnected.
USING THE ANSWERING MACHINE 4-9