Sending a Fax by Automatic Dialling
45
2. Sending
Documents
8
Return to Step 3 to store another
number, or press the
STOP
key to
return to the date and time display.
Chain Dialling for area and access codes
You can also store an area code or access code in a Rapid Key or
Speed Dial number. To use this number to dial, see
Chain Dialling
in
Chapter 5,
Making Telephone Calls
.
Note:
An area code or access code stored in a Rapid Key or Speed Dial
number can only be used if the handset is lifted or the
SPEAKER
key is
pressed before dialling.
Note:
Numbers stored for automatic dialling will appear on the Tele-
phone Number List printout, so this facility should not be used to store
least cost routing or system access passwords which need to remain pri-
vate.
STOP
FAX/TEL # MODE
1=SET,2=CLEAR
Step 3 or
Clearing auto-dial numbers
1
Press these keys:
The display will show:
3
Note:
To confirm that auto-dial numbers have been stored correctly, print
out the Telephone List. The procedure for doing this can be found in
Chapter 8,
Printing Lists
.
all-ux40.book Page 45 Thursday, November 18, 1999 2:35 PM
To Next Page
Loading...
Need help?
General
