Messages and Signals
73
10. Trouble-
shooting
Messages and Signals
Display messages
Note: If you have turnen on the Caller ID funciton, see Caller ID in Chapter 7
for display messeges related to Caller ID.
CHECK PAPER The thermal paper is jammed or isn’t loaded properly.
Remove and reload the paper. (See the following
section, Clearing Paper Jams.)
COVER OPEN The operation panel is open. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section, Clearing Paper Jams.
FUNCTION MODE The FUNCTION key has been pressed.
HOLD The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH key again to take the
other party off hold.
LINE BUSY This appears if you attempt to send a fax by
automatic dialling and the line is busy or the receiving
fax machine doesn’t answer. Press the STOP key to
clear the message.
LINE ERROR Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page 68.
MEMORY IS FULL
(FO-51/FO-71 only)
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible, resolve
the problem so that printing can continue, see
Substitute Reception to Memory on page 44.
NO DATA This appears if you attempt to search for an auto-dial
number when none have been stored.
NO # STORED You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn’t been programmed (a full
number hasn’t been assigned to it).
tsdm.FMPage73Friday,July19,20028:09AM
To Next Page
Loading...
Need help?
General
