Sharp UX-B20 - Page 19

UX-B20U/UX-B20C/B25C
2 – 6
7. How to make soft switch setting
To enter the soft switch mode, press the following key entries in sequence.
Press
FUNCTION
9 8 7 STARTSTART
Press FUNCTION key.
Press key.
Press key.
Bit1 - 8 are set.
Soft SW-A2 - SW-P7 are set.
S F T SW-A1 = 10000000
S F T SW-A1 = 10000000
S F T SW-A1 = 10000000
S F T SW-A1 = 10000000
S F T SW-A2 = 00000000
S F T SW-P7 = 00000000
Press key during setting.
To finish the settings halfway between
SW-A1 and SW-P7, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW No. remain in effect.
The soft switch mode is terminated.
S F T SW-A1 = 00000000
START
DATA No. 1 2 3 4 5 6 7 8
When the COPY key is pressed, the
contents of soft switches are printed.