Sharp VL-Z100S - Initial Camcorder Setup; Battery Pack Management

Preparation
5
Preparation
Attaching and
Removing the Battery
Pack
Attaching
1 Make sure that the Power
switch is set to OFF.
2 Open the LCD monitor to a 90° angle
to the camcorder body.
3 Slide the battery pack in the direction
of the arrow with the “m” mark facing
out.
4 Push the battery pack in the direction
of the arrow until it clicks.
Power switch
“m” mark
90°
VL-Z300S/VL-Z100S-GB-005-019 04.2.12, 1:54 PM5