21
Miscellaneous Settings
You can program miscellaneous settings using the following sequence:
1
➝
S
➝ ABCDEFGH ➝
S
(
➝
S)
Parameter A: Choice of date format
Value to enter: 0 for mmddyy, 1 for ddmmyy or 2 for yymmdd
Parameter B: Choice of time format
Value to enter: 0 for 12 hour system or 1 for 24 hour system
Parameter C: Choice of decimal point setting
Value to enter: 0, 1, 2 or 3
Parameter D: Choice of resetting receipt no. when issuing Z report
Value to enter: 0 for not resetting or 1 for resetting
Parameter E: Choice of amount tendered compulsory
Value to enter: 0 for not compulsory or 1 for compulsory
Meaning: When set for compulsory, always enter the amount tendered by the cus-
tomer before finalizing the transaction.
Parameter F: Choice of S compulsory
Value to enter: 0 for not compulsory or 1 for compulsory
Meaning: When set for compulsory, always press S before finalizing the transac-
tion.
Parameter G: Entry digit limit for G, g, R, and p
Value to enter: 0, 1, 2, 3, 4, 5, 6, 7 or 8
Parameter H: Rounding
Value to enter: 0 for rounding off, 1 for rounding up or 2 for rounding down
Example: Set the date format of ddmmyy (1), time format of 24 hour system (1) and decimal
point setting of 2 (2), do not reset the receipt no. with Z report (0), set the amount
tendered for not compulsory (0) and S for not compulsory (0), set the entry digit
limit of 8 (8) and rounding off (0). (These are the factory default settings.)
1S 11200080 S(S)
A B C D E F G H
DD
DD
D
• When entering parameters A to H, any leading zeros in the sequence can be omitted.
For example, if A=0, B=0, C=0, D=0, E=0, F=0, G=8, H=0, you can input 80.
• You can continue programming without printing the programming report by not
pressing the S key at the end of the program.
To Next Page
Loading...
