8
DD
DD
D
Always enter the date in 6 digits even when the month is in the single digit. For
example, enter 0111 for 1 November. If you change the date format in the
Z/PGM mode, follow the specified format when setting the date.
Check the Time and Date
You can display the time and date to check if they are correctly set.
1. Set the mode switch in the REG position.
2. Press the M key once to display the time.
3. Press the M key the second time to display the date.
Program VAT/tax
Before you can proceed with registration of sales, you must first program tax that is required by
your region. Your cash register comes with the ability to program two kinds of VAT/tax. VAT/tax
programming consists of two separate functions: 1. programming tax rate, and 2. associating
the correct departments as taxable and non-taxable departments. Your cash register comes
preprogrammed with all departments 1 to 5 assigned to taxable 1. If this does not fit your
needs, change the settings referring to the Department section on page 13.
Programming tax rate
Set the mode switch in the Z/PGM position and use the following sequence to program the tax
percentage:
9 ➝ S ➝ 1 for VAT/tax 1 or 2 for VAT/tax 2 ➝ x
➝ R ➝ x (➝ Q )➝ L
Parameter R: tax rate (0.0000% to 99.9999%)x10000
Enter the rate in 6 digits (leading zeros may be omitted). If the rate is fractional (e.g., 4 3/8%), it
should be converted to its decimal equivalent (4.375) before entering.
Parameter Q: Minimum taxable amount (0.01 to 99.99)x100
Smallest amount for which tax must be collected. It is valid only when you selectt the automatic
tax amount printing. It is invalid for VAT.
Example: Set a tax rate of 7% for VAT/tax 1. The minimum taxable amount is 0.11.
9S 1x 70000 x11 L
VAT/tax 1 Tax rate Min. taxable amount
Before Operation
To Next Page
Loading...
