27
Replacement
1. Be sure that the cash register is plugged in.
2. Set the mode switch key to the REG position.
3. Pull the printer cover upward and detach it.
4. Open the battery cover and remove the old batteries.
5. Install three new AA batteries into the battery
compartment.
6. Check that the “
ll
ll
l” symbol has disappeared.
7. Close the battery cover.
8. Replace the printer cover.
C
Incorrectly using batteries can cause them to burst or leak,
possibly damaging the interior of the unit. See the cau-
tions on page 6.
Paper Roll
When colored dye appears on the edges of the paper roll, it is time to replace the roll. Use
paper of 57 mm in width. To prevent jamming be sure to use the quality paper specified by
SHARP.
Replacement (in the case of journal printing)
1. Set the mode switch to the REG position.
2. Open the printer cover.
3. Press
ff
ff
f to advance the paper several lines. Remove the
take-up spool from the bearing.
4. After cutting the existing paper, remove the paper roll. Then
remove the remaining paper by pressing
ff
ff
f.
5. Remove the used journal paper roll (if used) from the
take-up spool.
6. Install a new paper roll and the take-up spool according to
the instructions on page 6.
DD
DD
D
In the case of receipt printing, do the above procedure 1,
2, 4 and 6.
Maintenance
To Next Page
Loading...
