29
Model: XE-A130
Size: 330 (W) x 380 (D) x 213 (H) mm
420 (W) x 436 (D) x 234 (H) mm (Large drawer type)
Weight: 4.3 kg
9.8 kg (Large drawer type)
Power Source: Official (nominal) voltage and frequency
Power Consumption: Stand-by: 6.5 W, Operating: 14 W
Working Temperature: 0 to 40˚C
Display: LED (Light-Emitting Diode) numeric display
Printer: 1 station print wheel selective type
Printing Capacity: Max. 14 characters
Paper Roll: Width: 57.5mm + 0.5mm
Max. external diameter: 80mm
Min. internal diameter: 12mm
Cash Drawer: 3 slots for bills, 5 for coins
4 slots for bills, 8 for coins (Large drawer type)
Accessories (supplied): Paper roll 1 roll
Manager key (MA) 2
Operator key (OP) 2
Drawer lock key 2 (located inside the drawer)
Instruction manual 1 copy (this manual)
Ink roller 1 (already installed)
Take-up spool 1
Before Calling for Service
If you encounter a problem, use this chart before calling for service.
Problem
• The display shows symbols that do
not make sense.
• The display will not illuminate even
when the mode switch is not set to
“o”. The machine fails to operate
when any key is pressed.
• The display is illuminated, but the
machine does not accept key
entries.
• Journal paper does not feed prop-
erly in the printer.
• Printing is faded or illegible.
Item to check
• Was the machine reset in the proper way shown on
page 5?
• Is the power supplied to the electrical outlet? (Plug in
another electrical device.)
• Is the power cord firmly connected to the electrical
outlet?
• Is the mode switch properly set to the REG position?
• Was the machine reset in the proper way shown on
page 5?
• Is the take-up spool installed properly?
• Is there a paper jam?
• Isn’t the ink roller used up?
• Is the ink roller installed properly?
Specifications
*Specifications and appearance are subject to change without notice.
To Previous Page
Loading...
