Sharp XE-A303

85
Part3
FOR THE MANAGER
Part2Part1
• When both sales quantities and sales amounts are zero, printing is skipped. If you do not want to skip,
change the programming. (Refer to “Print format” of “Various Function Selection Programming 1”.)
• “X” represents read symbol and “Z” represents reset symbol in the reports.
• To stop reading and resetting the PLU sales report, turn the mode switch to the MGR position.
The data will not be erased when you reset.
• The drawer does not open when you take X/Z reports.
The drawer can be opened by pressing the
A
key to remove the till after closing your business.
• When printing is performed continuously, the printing may be intermitted several seconds. After
the intermission, the printing will be restarted.
Item
Mode switch position
Key operation
OPX/Z X1/Z1 X2/Z2
X2, Z2
X2, Z2
Total in drawer
report
X1
X1 X2
2A
Reading:
--
--
--
--
--
X, Z
Full clerk report
Hourly report
(full)
X1, Z1
X1, Z1
--
--
--
--
--
Individual clerk
report
P
LL
Reading: Resetting:
P
LL
Reading: Resetting:
P
ss
Reading: Resetting:
Hourly report
(by range)
s@
Reading: Start time End time
Daily net sales
report
P
ss
Reading: Resetting:
(The report of the current clerk)
(hour) (hour)
A303_3(En) 06.7.22 4:41 PM Page 85