EN-9
■ Bluetooth
Bluetooth wireless technology is a short-range radio technology
that enables wireless communication between various types of
digital devices, such as mobile phone or computer. It operates
within a range of about 10 meters without the hassle of having
to use cables to connect these devices.
This unit supports the following:
Communication System: Bluetooth Specication version 2.1
Bluetooth + Enhanced Data Rate (EDR).
Support Prole : A2DP (Advanced Audio Distribution Prole)
and AVRCP (Audio/Video Remote Control Prole)
Notes when using unit with a mobile phone
● This unit cannot be used to talk over the telephone even
when there is a Bluetooth connection made to a mobile
phone.
● Please refer to the operating manual supplied with the mobile
phone for details on operation of your mobile phone while
transmitting the sound using a Bluetooth connection.
Bluetooth devices need to be initially paired rst before
they can exchange data. This unit can memorise up to a
maximum of 20 devices. Once paired, it is not necessary to
pair them again unless:
● pairing is made with more than 20 devices. Pairing can
only be made one device at a time. If subsequent de-
vice is paired, the oldest device paired will be deleted
and replaced with the new one.
● this unit is reset. All pairing information is deleted when
unit is reset.
Indicators:
Indicator Condition Bluetooth status
Lights up Connected
No indication Unconnected
However, the indication status is not displayed during
Bluetooth standby mode.
■ Pairing with Bluetooth source devices
1 Press the
(ON/STANDBY)
button to turn the power on.
2 Press the button on the main unit or BLUETOOTH
button on the remote control to select Bluetooth function.
“BLUETOOTH” appears on the display.
3 Perform pairing procedure on the source device to detect
this unit. “XL-BB20D SHARP” will appear in the detected
devices list (if available) in the source device. (Refer the
source device operating manual for details).
Notes:
● Place the devices to be paired within 1 meter of each
other when pairing.
● Some source devices are unable to display lists of de-
tected devices. To pair this unit with the source device,
refer to the source device operating manual for details.
4 Select “XL-BB20D SHARP” from the source list. If Pass-
code* is required, enter “0000”.
* Passcode may be called PIN Code, Passkey, PIN num-
ber or Password.
5 “Connected” appears on the display once the unit is suc-
cessfully paired with the source device. (Pairing information
is now memorised in the unit.) Some audio source devices
may connect with the unit automatically after pairing is com-
pleted, otherwise follow the instructions in the source device
operating manual to start connection.
6 Press the play button on main unit, remote control or source
device to start Bluetooth streaming playback.
Notes:
● If a device such as microwave oven, wireless LAN card, Blue-
tooth device or any other device that uses the same 2.4 GHz
frequency is placed near the system some sound interruption
may be heard.
● The transmission distance of the wireless signal between the de-
vice and the main unit is about 10 m, but may vary depending on
your operating environment.
● If a steel concrete or metallic wall is between the device and the
main unit, the system may not operate at all, because the wire-
less signal cannot penetrate metal.
● If this unit or the source device is turned off before Bluetooth con-
nection is completed, pairing will not be completed and the pair-
ing information will not be memorised. Repeat step 1 onwards to
start pairing again.
● To pair with other devices, repeat steps 1 - 5 for each device. This
unit can memorise up to a maximum of 20 devices. If subsequent
device is paired, the oldest device paired will be deleted.
● Once a device is ousted or deleted from the pairing list, the pair-
ing information for the device is also deleted. To listen to the
sound from the device again, it needs to be re-paired. Perform
steps 1 - 5 to pair the device again.
● XL-BB20D does not support Bluetooth prole AVRCP 1.4, hence
there will be no volume synchronisation even if your Bluetooth
device supports such prole.
Listening to Bluetooth enabled devices
XL-BB20D_OM_EN_DE_ES_FR_IT_PL.indb 9 2018-01-25 10:09:52
To Next Page
Loading...
Need help?
General
