EN-16
EN
Using the Radio Data System (RDS)
(continued)
3 Within 6 seconds, press the TUNING
( or )
button to select the programme type.
Each time the button is pressed, the programme type will
appear.
4 While the selected programme type is ashing (within
6 seconds), press the RDS PTY button again.
After the selected programme type has been lit for 2 sec-
onds, “SEARCH” will appear, and the search operation
will start.
Notes:
● If the display has stopped ashing, start again from
step 2. If the unit nds a desired programme type, the
corresponding channel number will lit for about 8 sec-
onds, and then the station name will remain lit.
● If you want to listen to the same programme type of
another station, press the RDS PTY button while the
channel number or station name is ashing. The unit
will look for the next station.
● If no station can be found, “Not Found” will appear for
4 seconds.
If you select the trafc programme:
If you select the trafc programme (TP) in step 3, “TP”
will appear.
(This does not mean that you can listen to the trafc infor-
mation at that time.)
When the trafc information is broadcast, “TA” will appear.
PTY (Programme Type) codes, TP (Trafc Programme)
and TA (Trafc Announcement)
NEWS POP M SOCIAL FOLK M
AFFAIRS ROCK M RELIGION DOCUMENT
INFO EASY M PHONE IN TEST
SPORT LIGHT M TRAVEL ALARM
EDUCATE CLASSICS LEISURE NONE
DRAMA OTHER M JAZZ TP
CULTURE WEATHER COUNTRY TA
SCIENCE FINANCE NATION M
VARIED CHILDREN OLDIES
Listening to the DAB+
■ About DAB+ (Digital Audio Broadcasting)
Digital Audio Broadcasting is a digital transmission system
where audio signals are converted to digital signals for
broadcasting. DAB+ is broadcast as a group of data called
multiplex (ensemble) which may contain one or more sta-
tions (services). Each station contains a primary service
and there may be one or more secondary services. This
allows several programmes or services to be transmitted
on a single frequency.
DAB + SIGNAL
MULTIPLEX
(ENSEMBLE)
SERVICES
SERVICES
COMPONENTS
(STATIONS)
■ Auto Scan
When turned on for the rst time, the unit scans radio sta-
tions automatically to create a station list.
To perform the Auto Scan again:
1 Press the TUNER [DAB] button until “DAB” appears
on the display.
2 Press DAB SCAN button on the remote control for
more than 3 seconds. Scanning begins.
+
The scanning progressThe number of received
station
The number of stations found and the scanning process
are shown on the display.
After the scan:
The rst station on the list will be selected and you will
hear it through the speakers.
● To listen to other stations, see “Selecting a station in
the station list” on page 17.
Notes:
● If no station is found, “No Service” appears.
XL-BB20D_OM_EN_DE_ES_FR_IT_PL.indb 16 2018-01-25 10:09:57
To Next Page
Loading...
Need help?
General
