EN-14
EN
Listening to the radio
■ Tuning
1
Press the (ON/STANDBY) button to turn the power
on.
2 Press the TUNER [DAB] button (remote control) or
INPUT button (main unit) repeatedly to select FM
Stereo or FM Mono.
3 ● Manual tuning:
Press the TUNING (
or ) button (remote
control) repeatedly to tune in to the desired station.
● Auto tuning:
Press and hold the TUNING ( or ) button.
Scanning will start automatically and the tuner will stop at
the rst receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING
(
or ) button again.
● When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed rst, and then the
RDS indicator will light up. Finally, the station name
will appear.
● Full auto tuning can be achieved for RDS stations
“ASPM”, see page 15.
To receive an FM stereo transmission:
● Press the TUNER [DAB] button to select stereo mode.
“ST” indicator will be displayed. “
” and “ ” will ap-
pear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER [DAB]
button to extinguish the “ST” indicator. The reception
changes to monaural, and the sound becomes clearer.
■ Memorising a station
You can store 30 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1 Perform steps 2 - 3 in “Tuning”.
2 Press the MEMORY button.
3 Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY button to store
that station in memory. If the “MEM” and preset num-
ber indicators disappear before the station is memo-
rised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that pre-
set channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
■ To recall a memorised station
Press the PRESET ( or ) button to select the desired
station.
■ To scan the preset stations
1
Press and hold the PRESET ( or ) button until the
preset number ashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the
desired station is located.
■ To erase entire preset memory
1
Press the
(ON/STANDBY)
button to turn the power on.
2 Press the INPUT button (main unit) repeatedly or
TUNER [DAB] button (remote control) to select Tuner
or DAB function.
3 In Tuner or DAB function, press and hold the CLEAR
button (remote control) until “Tuner Clear” or “DAB
Clear” appears.
XL-BB20D_OM_EN_DE_ES_FR_IT_PL.indb 14 2018-01-25 10:09:56
To Next Page
Loading...
Need help?
General
