Shell NewMotion Home Advanced 2.1 - Connecting the Charge Point to the DPM Module

30Installation manual – NewMotion Home Advanced 2.1 / 2.2 - 071NMEN13
RJ12

1 2 3 4 5 6 7 8
U
6. Strip ± 2 cm of the outer insulation from the DPM data cable.
7. Cut the wires in a straight line and insert six wires into an RJ12 connector, matching the wires (see gure 42).
8. Secure the connector to the wires using an RJ12 crimp tool.
The DPM module is now installed and prepared for connection to the charge point.
5.7.2. Connecting the charge point to the DPM module
Connect the charge point to the DPM module on the consumer unit following the steps below.
1. Ensure that phases L1, L2 and L3 of the charge point connection match phases L1, L2 and L3 on the DPM module.
2. Take the DPM data cable that leads to the consumer unit.
RJ12

1 2 3 4 5 6 7 8
I
3. Strip ± 2 cm of the outer insulation from the DPM data cable.
4. Cut the wires in a straight line and insert 6 of the wires into an RJ12 connector, matching the wires (see gure 43).
5. Secure the connector to the wires using an RJ12 crimping tool.
6. Check if you have properly installed the connectors on both sides using an RJ12 network cable tester.
EN