14
Operations
ENGLISH
LISTENING TO A PROGRAM SOURCE
Before operation
• Enter the standby mode.
• The STANDBY indicator lights up.
This means that the receiver is not
disconnected from the AC mains and a small
amount of current is retained to support the
operation readiness.
• To switch the power off, push the POWER
switch again.
• Then the power is cut off and the STANDBY
indicator goes off.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button to
enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button is
pressed, the receiver is turned on automatically and the
desired input is selected.
• Then “SPK ON” is displayed and the sound can be heard
from the speakers connected to the speaker terminals.
• When using the headphones for private listening, press the
SPEAKER button again to switch the speakers off(“HP ON”
is displayed).
• Each time the “VIDEO” button on the front panel is
pressed, the input source changes as follows:
VIDEO 1 ↔ VIDEO 2
• Each time the “AUDIO” button is pressed, the input source
changes as follows:
→Tuner ↔CD → TAPE → AUX1 → AUX 2
(Frequency display)
• Each time the BAND button (or the TUNER button on the
remote control) is pressed, the band changes as follows:
→FM ST →FM MONO →AM
1. In the standby mode, turn the power on.
2. Switch the speakers on.
3. Select the desired input source.
■Note : Before operating this receiver, first set this unit as desired for optimum performance, doing the system
setup procedures. (For details, refer to "System Setup" on page 29.)
When CD,VIDEO 1~ 2 is selected as an input source
4.Select the digital or the analog input connected as
desired.
• Each time this button is pressed, the corresponding input is
selected as follows:
→ o(ptical) → c(oaxial) 1 → c(oaxial) 2 → A(nalog)
■Notes :
• When Tuner, AUX 1~2 or TAPE is selected as an input
source, the analog input is selected automatically.
• When the selected digital input is not connected, the "DIGITAL"
flickers and the analog input is automatically selected.
• The selected digital input or analog input is automatically
assigned to the corresponding input source on the INPUT
setup menu. (For details, refer to “When selecting the
DIGITAL IN” on page 33.)
• The sound from the component connected to the selected
digital input can be heard regardless of the selected input
source.
RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 14
To Next Page
Loading...
Need help?
General
